| From | Message |
Rebuilt dodge
Dodge Dakota
JOIN HERE
12/06/2010
23:02:47
|
 Subject: coil voltage
IP: Logged
Message:
1990 3.9L auto trans. what is the correct coil voltage to the coil when running and when just starting? is it a straight 12 volts or is there a resistor in there some place. like dodge used to do on the firewall?
|
Shocker
Dodge Dakota
JOIN HERE
12/23/2010
17:00:04
| RE: coil voltage
IP: Logged
Message:
220 volts.
|
Rebuilt dodge
Dodge Dakota
JOIN HERE
12/23/2010
18:23:28
| RE: coil voltage
IP: Logged
Message:
blank you.
|
dakota49
Gen I
12/23/2010
19:17:54
| RE: coil voltage
IP: Logged
Message:
Rebuilt Dodge, it should be 12 volts, or what ever the battery voltage is, usually its slightly lower than battery voltage though
Good Luck
Dakota49
dakota49
|
Rebuilt dodge
Dodge Dakota
JOIN HERE
12/23/2010
19:20:12
| RE: coil voltage
IP: Logged
Message:
thank you.
|
dakota49
Gen I
12/25/2010
00:05:11
| RE: coil voltage
IP: Logged
Message:
Rebuilt Dodge, you are welcome, let us know how it runs when you get it going.
Dakota49
1988 3.9 5speed 4X4
dakota49
|
Rebuilt dodge
Dodge Dakota
JOIN HERE
12/25/2010
05:23:56
| RE: coil voltage
IP: Logged
Message:
well i fixed it over a week ago. the wires going ot the pickup in the dist had been eaten off by a rat. and there was another wire that had been ran from under the dahs and spliced into the harness. i swapped out the dist pick wire and the engine bay wiring. and hooked up the one wire from under the dash and the truck started and ran fine. i now need to swap the under dash harness to get away from that single rigged up wire. but it runs as is right now.
|
sprocket1200
Dodge Dakota
JOIN HERE
1/01/2011
12:36:00
| RE: coil voltage
IP: Logged
Message:
try dodgeforum.com. there you can go to the faq section of the
dakota area and find the service manuals electronically. they have
the testing procedures and specs. super useful!
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
