Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
18:00:38 - 11/14/2024

V6 Dakotas
FromMessage
STEWART JARRA
Dodge Dakota
JOIN HERE
 Email

3/17/2007
09:45:00

Subject: STARTING PROBLEM
IP: Logged

Message:
WANT TO PUT A 4 POT HOLLEY ON INSTEAD OF FUEL INJECTION ON MY 3.9L AUTO 2WD CAN ANY ONE SUGGEST A MANIFOLD TO FIT.



J and J Auto
GenII
 Email User Profile


3/20/2007
02:40:03

RE: STARTING PROBLEM
IP: Logged

Message:
There is none

You would have to use a set of 88 to 91 heads
and find a 4 bl intake

These heads have rocker shafts and a 1.5 ratio
your mag has 1.6

now you would have to change ignition and lots
of wireing why in the world would you want to
do something like this

Not a good idea

Larry
J&J Auto

well
Dodge Dakota
JOIN HERE


3/20/2007
08:46:55

RE: STARTING PROBLEM
IP: Logged

Message:
seems to me he's looking for less horse power
and lower MPGs



stewart
Dodge Dakota
JOIN HERE
 Email

4/01/2007
11:17:53

RE: STARTING PROBLEM
IP: Logged

Message:
my dakota 3.9litre auto broke down it struggled to run so i turned it off and never run since it has no spark ive changed the crank sensor distributer cap rotary leads ecu and coil still no joy and suggestions please



maybe
Dodge Dakota
JOIN HERE


4/01/2007
13:42:54

RE: STARTING PROBLEM
IP: Logged

Message:
what year?
possibly the under hood wire splice



stewart jarra
Dodge Dakota
JOIN HERE
 Email

4/05/2007
09:44:27

RE: STARTING PROBLEM
IP: Logged

Message:
its 1992 and where would i find this please,



daddio
Dodge Dakota
JOIN HERE
 Email

4/05/2007
10:00:47

RE: STARTING PROBLEM
IP: Logged

Message:
there is a wire splice you need to check. it's in the harness about 6- 8 inches after it leaves the PDC(power dist. box). 4 wires into 1. you'll have to peel the insulation back to see it. even it if looks ok redo it. preferably soldering it.



more help
Dodge Dakota
JOIN HERE


4/05/2007
10:21:34

RE: STARTING PROBLEM
IP: Logged

Message:
daddio has you headed in the right dirrection
in the engine bay find the under hood fuse/relay box
(black) on the inner fender well (drivers side) right near the battery
remove the box un-do the black tape holding the wire's together
once you have the wires exsposed your looking for a splice of 3 or 4 wires (solder together)
mine were red and white
the solder joint will be all cruded up
maybe even snapped off
cut out the bad stuff
re-do the splice and tape it all back up nice to keep water out
and you should be good
90% of the time the problems your talking about are from this splice
good luck and give us and update



daddio
Dodge Dakota
JOIN HERE
 Email

4/05/2007
11:09:37

RE: STARTING PROBLEM
IP: Logged

Message:
thanks for clarifying that more help. as i probably won't have to redo that splice (i've got an '00) i was going from memory of what i read about it.



clyde
Dodge Dakota
JOIN HERE
 Email

4/07/2007
20:01:55

RE: STARTING PROBLEM
IP: Logged

Message:
hi clyde here
I have a 1989 dodge dakota 2wd woriing fine last week but now won't start , if it's the fuel pump would it stop producing spark to the plugs, seems like it is clicking in but don't here it pumping when key is turned on. thanks



clyde
Dodge Dakota
JOIN HERE
 Email

4/07/2007
20:10:00

RE: STARTING PROBLEM
IP: Logged

Message:
hi clyde here
I have a 1989 dodge dakota 2wd woriing fine last week but now won't start , if it's the fuel pump would it stop producing spark to the plugs, seems like it is clicking in but don't here it pumping when key is turned on. thanks
P.S. it turns over good ,starter not the prob.



clyde
Dodge Dakota
JOIN HERE
 Email

4/07/2007
20:15:39

RE: STARTING PROBLEM
IP: Logged

Message:
hi clyde here
I have a 1989 dodge dakota 2wd woriing fine last week but now won't start , if it's the fuel pump would it stop producing spark to the plugs, seems like it is clicking in but don't here it pumping when key is turned on. thanks
P.S. it turns over good ,starter not the prob.

SORRY>>> forgot to click the yes to notify me when i get a reply lol i also tried primimg it but with no luck. won't burn the primer.



stewart jarra
GenI
 Email User Profile


5/16/2007
08:57:06

RE: STARTING PROBLEM
IP: Logged

Message:
hi done the wire slices apart from one a grey which doesnt seem to go any where any ideas where it goes its two grey wires and a black are they a earth?.many thanks



Kelly
Dodge Dakota
JOIN HERE
 Email

7/15/2011
15:14:13

RE: STARTING PROBLEM
IP: Logged

Message:
I have a 1989 Dodge Dakota Sport V6 3.9 every time i start it i have to give it gas or it will stall out. I have replaced the fuel filter and put sea foam in the tank any other suggestions of why this is happening?



well
Dodge Dakota
JOIN HERE


7/16/2011
10:21:20

RE: STARTING PROBLEM
IP: Logged

Message:
It could be 101 things.

weak coil
weak fuel pressure
plugs
cap
rotor
wires



kelly
Dodge Dakota
JOIN HERE
 Email

7/16/2011
12:36:11

RE: STARTING PROBLEM
IP: Logged

Message:
Where is the fuel pressure regulator
located on a 89 dodge Dakota sport?



Bob Lincoln
Dodge Dakota
JOIN HERE


7/18/2011
08:32:31

RE: STARTING PROBLEM
IP: Logged

Message:
Could also be a weak battery, or a bad TPS.



DCBones
Dodge Dakota
JOIN HERE
 Email

7/18/2011
09:37:21

RE: STARTING PROBLEM
IP: Logged

Message:
Well if the fuel pump is priming and there is spark, and fuel rail has pressure/ fuel, could the injectors be the culprit? Is there a relay/ fuse for the injectors?



Jimmy
Dodge Dakota
JOIN HERE
 Email

10/22/2012
22:27:29

RE: STARTING PROBLEM
IP: Logged

Message:
1989 dakota wii not start, I ran a wire from pos off the batters
to the coil and it will run good



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.