Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
18:09:56 - 11/14/2024

V6 Dakotas
FromMessage
J and J Auto
GenII
 Email User Profile


9/01/2009
03:58:10

Subject: RE: Waking up the Magnum 3.9????
IP: Logged

Message:
start with the free mods

crank sensor mod
remove sensor slot holes 3/8" remove rubber gromit
and move down towards oil filter when you do this
go 1 colder on the plug NGK Vpower FR5 gap .040


IAT relocate 6" from throttle body in air tube
drill 1/2" hole and screw in does not need to be
grounded if wires need to be extended solder them
and it does not matter wich wire goes to which
side

throttle position sensor
take a drill jusr bigger than bushings so it hooks
than spin bushings they will get hot and gently
push them out, clean any burs with file
now use 2 little washers do not over tighten
key on engine off center wire pos and good
ground I go right to batt terminal and set this
to .75 volts

these 3 free mods are very noticeable when all
done togather give it 200 miles to learn and
you will feel the diff

when ever you change the tps volts you will need
to start and stop the motor 3 times so it learns
the new idle volts it will idle high the first
few starts and than settle down

go 1 colder plug after this
NGK Vpower FR5 and gap at .040 on your 2000

next cold air setup and a bigger throttle body
than do the exhaust always get more in before
freeing up the exhaust the dynomax 11748 and a
factory 2 1/2 tail will give you the best low end
torque than think about headders and the 1.7
roller rockers

the dynomax can be done any time but don't do the
headders untill the intake side is improved

when all this is done you will have a very nice
running truck than think about the superchips
tunner

All this will come in around a grand and you will
gain 30 to 50 rear wheel hp

if any of these mods make it run worse that will
tell you your o2 sensors are bad when you flow
better and it runs worse it is not increasing
the fuel as it should

Larry
J&J Auto

yogi bear
Dodge Dakota
JOIN HERE
 Email

9/08/2009
18:43:28

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
after paying 75 for a old greasy dirty throttle body i said i need the cable also they said it would be a nother 47 i told them 2 shove it i hope its cheaper some were else



yogi bear
Dodge Dakota
JOIN HERE
 Email

9/09/2009
17:43:29

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
im bout 2 go get the throttle cable and install it but how do you get the linkage off the pedal



Jonas
Dodge Dakota
JOIN HERE
 Email

9/09/2009
17:54:03

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
I bought a Holley replacement ball stud set for about $15.00 and drilled the throttle body linkage instead of buying a cable. I have a 5-speed manual. It works fine and I still have my original throttle cable.

1.V8 Throttle Body
2.TPS @ .79
3.Cold Air Intake
4.IAT Relocation
5.CPS Mod
6.NGK FR5 V Power Plugs @ .040
7.Napa MO26 & MO28 Cap and Rotor
8.Set Injector Sync +3



yogi bear
Dodge Dakota
JOIN HERE
 Email

9/09/2009
20:06:07

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
im done and i didnt notice crap it seems like a waist of 120 and i reset the comp so i hope it gets better



troy builts
Dodge Dakota
JOIN HERE


9/09/2009
20:58:27

RE: jonas Waking up the Magnum 3.9????
IP: Logged

Message:
i did the same thing with my linkage...cheap fix...im still having problems with the tps mod...look for my name in the sidebar of the forum...daddio tried to help me but i still cant get full throttle on the scanner....with the voltage mods all i got was 80 percent wot



troy builts
Dodge Dakota
JOIN HERE


9/09/2009
21:03:40

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
if you take off the tps and plug it in and turn it by hand , you get 98.9 percent wot but when you put it on with taking out the sleeves and filing the most i can all i can get is 80.8 percent wot



yogi bear
Dodge Dakota
JOIN HERE
 Email

9/09/2009
21:27:19

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
when i put mine on it set offset and had 2 turn it 2 bolt it back on and it wasnt like that on my v6 tb



yogi bear
Dodge Dakota
JOIN HERE
 Email

9/09/2009
22:32:20

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
i just mesured my tps and it was .62 volts would it benfit me 2 tune it 2 .7



daddio
Dodge Dakota
JOIN HERE
 Email

9/10/2009
08:47:05

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
I don't think you'd notice a difference. Mine stock, was .53vdc and I noticed a little difference going to .7vdc but not that much. A little crisper throttle response.



yogi bear
Dodge Dakota
JOIN HERE
 Email

9/10/2009
13:55:15

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
didnt think so do you y i havent noticed any thing with the tb



Jonas
Dodge Dakota
JOIN HERE
 Email

9/10/2009
13:55:31

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
"If you take off the tps and plug it in and turn it by hand , you get 98.9 percent wot but when you put it on with taking out the sleeves and filing the most i can all i can get is 80.8 percent wot"

Hi,
I think what they were trying to help you with is the computer will use the 80.8% as WOT.And the lowest number for closed throttle.I am not a mechanic but I would just set it at .7 or .75 and forget it.
I am looking at buying Harland Sharp roller rockers at some point in the near future.
Hope this helps.
Jonas



daddio
Dodge Dakota
JOIN HERE
 Email

9/10/2009
14:36:19

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
"im done and i didnt notice crap it seems like a waist of 120 and i reset the comp so i hope it gets better"

Yogi, you probably should have shopped around a little more. Here is what I've done and I did notice a difference.

Underdrive Crank pulley only - second hand - $25.00
TPS mod - $0.00
CPS mod - $0.00
IAT mod - $0.00 (Now I have put the IAT back to stock. My truck didn't like that.)
Ported V6 TB - $0.00 OK
Stock V8 TB - $20.00 Better than V6 TB
Removing the stupid snorkel on the airbox - $0.00
Setting Inj. Sync - $0.00 It should be somewhere around +3.
1.7 Crower RR's - $325.00(never installed. sold for $350.00)

Cherry Bomb Turbo Muff- $15.00

So, I think I'm out $35.00. Worth it to me.

My '00 QC 3.9 5spd, 4x2 w/ 3.55:1 gears and 235/75/15 tires get about 18mpg in town and as much as 24.4mpg hwy. And it has way more pep than when I started out.




yogi bear
Dodge Dakota
JOIN HERE
 Email

9/10/2009
19:57:13

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
i have the tps mod single glass pack dumped cai 180 t-stat idk what the follwing parts are thw were on when i got the truck
new injectors
new plugs&wires 7mm super max wires
and v8 tb
and i thank it has been chiped what else can i do it cant even smoke tires



yogi bear
Dodge Dakota
JOIN HERE
 Email

9/10/2009
20:09:45

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
i have the tps mod single glass pack dumped cai 180 t-stat idk what the follwing parts are thw were on when i got the truck
new injectors
new plugs&wires 7mm super max wires
and v8 tb
and i thank it has been chiped what else can i do it cant even smoke tires



pssst
Dodge Dakota
JOIN HERE


9/10/2009
22:10:33

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
Correct me if I'm wrong but isn't this truck a full size ram with a 3.9 ?



DakotaGuy
Dodge Dakota
JOIN HERE
 Email

9/11/2009
13:52:51

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
So you can put a V8 Throttle Body on a 3.9L Magnum???



yogi bear
Dodge Dakota
JOIN HERE
 Email

9/11/2009
20:31:33

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
yup shure is but iv beat every 3.9 ram wher im from so they can suck it lol but yeah its a ram



yogi bear
Dodge Dakota
JOIN HERE
 Email

9/12/2009
12:46:31

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
what are the trq. Cones iv herd 2 cut them off are they talkin about the lil wall thats around the bore



withheld
Dodge Dakota
JOIN HERE


9/12/2009
13:31:57

RE: Waking up the Magnum 3.9????
IP: Logged

Message:
Yes



  <<Previous Page P 2 Next Page>>


 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.