From | Message |
Buddy Jones Dodge Dakota JOIN HERE
1/29/2003 20:50:31
|
Subject: Spintech IP: Logged
Message: I was looking at a friend's new issue of Truckin' magazine and found a tech article on installing a Spintech 3" true dual exhaust w/X-pipe on an R/T(not sure on the year).Well anyways, down to the point.They said they gained 40 HORSEPOWERER!That blew my mind.I now think they're #1 for power gains.Oh, and it was the side exit.
Anyone seen better?
|
HSKR Dodge Dakota JOIN HERE
1/29/2003 21:08:16
| RE: Spintech IP: Logged
Message: Don't expect the same gains out of every vehicle. The truck it was installed in is a Paxton supercharged 408 stroker with nitrous.
|
ShortSport GenIII
1/29/2003 23:05:35
| RE: Spintech IP: Logged
Message: i,ve said it before i'll say it again ...if it seems to good to be true it usually is
2002 Reg cab 4x2 4.7 5-spd 3.55.1 LSD fiberglass tonneau cover; stainless steel cat-back dual exhaust; magnaflow muffler Go hard or go home!!
|
Scott Q Dodge Dakota JOIN HERE
1/29/2003 23:30:21
| RE: Spintech IP: Logged
Message: the 40 hp gain is on a s/c 408.
You can expect similar gains on a s/c 360 or
a 408 that is lightly modded.
The gain measured is from a single 3" to a
dual 3" through race mufflers with an x pipe,
this type of gain is not uncommon and the set
up sounds awesome.
Scott
|
Cerecke GenIII
1/30/2003 13:45:06
| RE: Spintech IP: Logged
Message: Hey scott, Saw the buildup of your truck in the latest issue of truckn magazine....Had a question for you, In your 408, it didnt mention if the crank you used was forged or cast. Im building a 408 and was wondering what you had in your setup. Thanks
Brandon
|
Buddy Jones Dodge Dakota JOIN HERE
1/30/2003 19:57:35
| RE: Spintech IP: Logged
Message: Are you the same Scott?I thought you were, just wasn't sure.
|
Scott Q Dodge Dakota JOIN HERE
1/30/2003 23:54:18
| RE: Spintech IP: Logged
Message: The crank is cast
and yes thats me
Scott Quaranta
|
| P 1 |
|
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
|