Forums
Forum Tools
|
 |
18:16:47 - 11/14/2024
Dakota Performance
| From | Message |
CrapShoveler
Dodge Dakota
JOIN HERE
11/26/2004
10:08:06
|
 Subject: Throttle Body too big?
IP: Logged
Message:
Right now I have K&N Generation One Air Intake, Harland Sharp 1.7 Roller Rockers, a MSD 6A Ignition Amp., MSD Blaster Coil, Accel Distributor Cap and Rotor, MSD 8.5mm Red Super Conductor Spark Plug Wires, a 180 Degree Jet Thermostat, a Mopar Performance PCM, Relocated IAT, Gibson Headers, Dynomax Super Catalytic Converter, and Edelbrock RPM Series Muffler. I currently have a Holley 52mm throttle bodie on it. Do you think that this is too big for my mods? Should I go to a 50mm? Any ideas are welcome.
|
b1llyw
GenII
11/26/2004
10:57:47
|  RE: Throttle Body too big?
IP: Logged
Message:
I would have suggested a 50mm but I don't think you are hurting yourself too bad on your 318.
Bill White - KRC Performance
'95 CC 4x2 - 408, 5-speed, 8 3/4
'04 Liberty, 4x4, 3.7, 5-speed, LSD
|
CrapShoveler
Dodge Dakota
JOIN HERE
11/26/2004
11:39:39
|  RE: Throttle Body too big?
IP: Logged
Message:
Thanks, I just wanted to make sure that I wasn't killing my torque or anything.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
