Forums
Forum Tools
|
 |
18:08:13 - 11/14/2024
General Dakota Board
| From | Message |
zzark
*GenII*
5/25/2006
10:59:42
|
 Subject: CPS mod comments
IP: Logged
Message:
I did the CPS mod on my 94 V6.
I had the sensor with the bushings in the plastic bracket.
I bought a new sensor, so no problem.
The plastic bracket is much thicker than the metal one,
so the existing bolts won't fit without shims. I screwed on a nut
and added one washer.
My bolts were allen heads, not hex. Which was not a problem
after I bought an allen socket set. In fact, it was probably
easier than having hex bolts.
I had to swing the trans fill tube out of the way.
I checked the timing before, both while running and just cranking,
and got 6.
After the mod I freaked 'cause I couldn't see the timing mark.
Then I realized it was up underneath. So it looked like it was
at 12. (the scale only goes to 6)
Larry said stock should be 10, and after should add 2-3.
So why did mine add 6 degrees?
Anyone else experience that?
BTW, the truck runs great.
zzark
|
?
Dodge Dakota
JOIN HERE
5/26/2006
13:03:45
| RE: CPS mod comments
IP: Logged
Message:
It will probably "correct" at least a little
as soon as the computer 'learns' the [ new ]
setting..
Otherwise , welcome to the world of POWER..
|
Bump
Dodge Dakota
JOIN HERE
6/01/2006
02:23:19
| RE: CPS mod comments
IP: Logged
Message:
Bump
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
