Forums
Forum Tools
|
 |
17:38:47 - 11/14/2024
General Dakota Board
| From | Message |
MACE
Dodge Dakota
6/27/2001
08:47:15
|
 Subject: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
'When too big might be bad'!
Ok, just installed the IntensePerformance z-tube with their new Pro-Flow filter, 9 inches, looks like a big mouth.
Think I got a too big of a filter..it sticks out almost all the way to the grill but the left half of it is being blocked by some piece of engine
component, looks like a big heat sink (ok, so what is that piece?).
The right half is up against where the rubber flap in the grill used to be, so cold air is getting into the filter.
Should I send this filter back and get a 7 inch filter? The sides of the filter have free airflow, and looking inside the front of the filter shows a cylinder type shape, perhaps there is still enough airflow in the front from the unblocked side, to work as advertised?
BTW, gotta love the sound of a z-tube and flowmaster catback during WOT!
However, would you believe within 1 minute of my first test drive, getting onto a entrance ramp of a highway to really test out the install, I had a cop follow me, on the highway, changing lanes behind me, back and forth, then followed me off the highway, trailed me, then did a U turn to get back on the highway going in a different direction?
Figured he must be admiring my tonneau cover with sport wing and 3 inch chrome dual exhaust...I did see him talking on his radio also...bastard!
Went home, checked for leaks (also istalled a 180 t-stat), went out and then was able to enjoy multiple launches and WOT...great sound!
|
Jason O.
Dodge Dakota
6/27/2001
13:00:39
| RE: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
Did you get any performance gains or just sound with the add-ons?
|
Art
Dodge Dakota
6/27/2001
13:15:04
| RE: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
Mace I have the same setup,mines about 4 inches from the rubber flap that your talkin about,you hooked up the tube right to the throttle body not to the stock air hat right?
|
MACE
Dodge Dakota
6/27/2001
13:33:50
| RE: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
The install was per directions, stock airhat removed, connected right to the middle front of the TB. I think with the new Pro-Flow 9 inch filter, the metal ends are longer than the older 9 inch Big-Mouth filter, hence the extended distance of the filter sticking out.
Re: performance gains, before the install, I had a Flowmaster SUV 50 catback and Jet II chip. With the z-tube, a Robert Shaw 180 t-stat and Autolite 3923s gapped at .040 were installed. The PCM was NOT reset, gas tank topped off with 6 gallons of 93 octane.
YES...besides that great sound, seems I launch into 2nd quicker with more ummph, thrust, whatever you want to call it...butt dyno feels it, get more of a sense of being pushed back in the seat, and 75-80mph comes real quick from punching it from 55MPH
I just had JET CHIP email me that resetting the PCM doesn't clear their chips programming, so tonight, I'll reset the PCM.
|
Art
Dodge Dakota
6/27/2001
13:39:20
| RE: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
mace i got the 9 inch pro-flow aswell its the same lenght just fatter bout an 1 1/2 inches bigger around and a better bell shape maybe the diff is I dont have a/c,is there something that sits there with the a/c?
|
MACE
Dodge Dakota
6/27/2001
13:50:20
| RE: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
Art, yes, I have A/C
What is your tube resting on, say about 1/3 to 1/2 way out from the TB, right over the engine block?
|
Art
Dodge Dakota
6/27/2001
13:54:20
| RE: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
its not resting on anything mace,i did make a lil plate to go under it tho bolted it to the intake where the stock airhat was bolted down,I`ll take a pic of it tomorrow show ya
|
MACE
Dodge Dakota
6/27/2001
14:13:58
| RE: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
Thanks Art, looking forward to the picture.
BTW, what type of exhaust do you have and did it seem that the z-tube woke up the exhaust, sound-wise?
|
Art
Dodge Dakota
6/27/2001
14:27:22
| RE: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
I got the mbrp dual rear cat,the truck is way better over 2500 musta picked up lil t/q aswell cause tires light up real easy now,whats ur email dont know how to post pics on here,if ya like it loud which I do it sounds great,im sure yours does to0,you got the jet chip how do you like it?I ordered bernds IAT figure that will do as much as the jet when its hot out and I dont wanna run 92 octane,gas is expensive here anyway whats your truck config you must be like 20-30 horse better than stock with those mods
|
MACE
Dodge Dakota
6/27/2001
14:58:53
| RE: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
Art:
Email: pmacey@ans.net
I have AWD, can't seem to get the tires to chirp, will keep on trying.
The JET II went in the same time as the Flowmaster, they seem to have complimented each other..I'm gonna stick with 89 octane for a month, see how it performs.
I have a 4.7/Auto/3.92/LSD/T&H/Sport+, thinking with the Flowmaster, chip, z-tube w/9in Pro-Flow filter, 180 t-stat, and 3923s, maybe 25-30 extra HP, possibly 45-50 more ft/lbs of torque, if you believe the advertising...certinaly no slouch, none the less and it sounds great!
|
Tad_W
Dodge Dakota
6/28/2001
11:28:28
|  RE: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
How does the small air hose to the stock air box attach to the ztube? Some type of fitting??
2000 qc sport 4x4 4.7 auto
|
Art
Dodge Dakota
6/28/2001
13:24:03
| RE: 4.7 Owners with Z-tube, Qs?
IP: Logged
Message:
There is a nipple on the z-tube for it but you need a longer peice of hose,connects up real easy tad
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
