Forums
Forum Tools
|
 |
17:46:58 - 11/14/2024
General Dakota Board
| From | Message |
ANDE
Dodge Dakota
JOIN HERE
12/10/2003
03:36:08
|
 Subject: Overhead console removal,,,HELP!
IP: Logged
Message:
I have a 99 Dak, C/C with the long overhead console with the computer and stuff in it.
I need to remove it to remove and replace a damaged headliner, but other than two screws in the front of the console, I cant find anything else holding it in.
I dont want to damage it buy yanking it loose, so Ive come to you guys for some help.
How the heck do I remove this thing without breaking it????
Any help is GREATLY appreciated.....
ANDE
|
Mikey
Dodge Dakota
JOIN HERE
12/10/2003
15:00:45
|  RE: Overhead console removal,,,HELP!
IP: Logged
Message:
There's two spring clips, one on each side, about midway, holding it up. Just pull the console down and they'll pop loose.
|
jaggy
GenIII
12/11/2003
13:30:01
| RE: Overhead console removal,,,HELP!
IP: Logged
Message:
I take the front screws out and work my fingers into the space and then work them back to the spring clips. I use this method on all of the pannels because you can feel the tension point and figure out exactly where the ancors are.
Other than that just pull down like Mikey said.
(I use my thumbs to push up on the headline and down with the fingers I worked into the space.)
Keep in mind that there are wire looms conected to the console. So don't pull down too hard.
good luck.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
