Forums
Forum Tools
|
 |
17:56:48 - 11/14/2024
General Dakota Board
| From | Message |
Scott
Dodge Dakota
JOIN HERE
7/07/2003
12:26:06
|
 Subject: M1 install on 2003?
IP: Logged
Message:
I just recieved my M1 intake and before installing have a few questions. Will the timing belt work with the offset A/C brackets? This is particularily inport to me since I have a Vortech supercharger and the belt size is not stock (and the size is unknown).
Also, can I reuse the existing water neck? These two issues were unclear in the instructions and I have seen conflicting info posted.
Thanks,
Scott
|
Lew360
Dodge Dakota
JOIN HERE
7/07/2003
23:24:05
|  RE: M1 install on 2003?
IP: Logged
Message:
Which intake did you buy, the 2bbl. or the 4bbl.? If you have the 4bbl. version you need the smaller idler pulley from Randy Pyle and a water neck from a LA motor. If you have the 2bbl. everything is a direct bolt-on. You can find good instructions for the 2bbl. here http://www.madrt.com/m1install.html and if you have the 4bbl. here http://www.steigerperformance.com/ under product documentation MPI intake install guide. HTH
'99 DA RC R/T, PPH Headers, Flowmaster 50 series, No Cat, MSD 6a, BTM, IAT adjuster, Powerdyne Supercharger, M-1 4/2, Mopar PCM
|
Scott
Dodge Dakota
JOIN HERE
7/07/2003
23:28:32
|  RE: M1 install on 2003?
IP: Logged
Message:
Thanks for the reply! I have the 2 bbl version.
Scott
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
